911 GT3 R 992 Rennsport Flacht Design Livery Wrap Kit — White, Red & Black

The Flacht design scheme off the 992 GT3 R Rennsport, cut as one coordinated kit for a car that is being wrapped from bare paint. The layout is built on three blocks rather than a single colour: the upper body and bonnet in white, a red graphic band, and solid black for everything below and above, so the kit is supplied as separate cut panels for each block rather than one sheet. The red band is the hardest part to get right and is cut in three sections: it starts on the front wing, arcs up and over the front wheel arch and then tapers as it sweeps backwards along the flank, getting narrower towards the rear quarter. The black block covers the whole roof, both sills and rocker panels, the front bumper, the front splitter and the rear bumper, with a black panel strip along the base of the windscreen. The rear wing is supplied as a red blade, black endplates and black uprights with the red trim line on the endplates. Every panel is blank, including the door roundel, the windscreen sunstrip and the wing surface, so no branding or race number is reproduced: you add your own, or we cut your lettering and number for you. Cut from 3M 2080 Series cast film with a 7-year outdoor durability rating, thin enough to follow the GT3 R arch flares, vents and the wing endplate edges, supplied with application tape, a felt-edge squeegee, tape-line guides for the arch curve and the taper of the red band, and a fitting guide. Fits the 992 GT3 R racing body. Around 6 hours of work.