911 RSR 930 Kremer Lower Flank Stripe & Lettering Panel Kit

The lower flank detail from the Kremer 1973 RSR rally car, supplied as a mirrored pair. Each side gets the banded stripe block that runs along the lower door and continues onto the sill between the wheel arches: a thin red stripe on top, a wider yellow stripe running through the middle and a thin purple stripe below, all three cut to length and stacked with even spacing so they sit parallel. Set inside the band is a black rectangular panel sized for the door lettering, left blank, and each door gets its own roundel, a white circle left blank so you can run your own number or ours. A short black valance trim strip is included for the front, and blank panels are supplied for the rear quarter. The stripes are cut with a small overhang at each end so the block can be aligned on the door and trimmed at the arch edges. Cut from 3M 2080 Series cast film with a 7-year outdoor durability rating, thin enough for the flared arch and sill lip, supplied with application tape, a felt-edge squeegee, tape-line guides for the three stripe heights, and a fitting guide. Fits the 1973 RSR and the 930-era classic 911 bodies. Around 2 hours of work.