Wheel Decal Installation Guide

Tools you will need

• Squeegee
• Isopropyl alcohol
• Cotton buds
• Heat gun
• Trim tool

Step-by-step instructions

1. 1

   Remove Wheels if Possible

   For the best results, remove the wheels from the car. This allows you to work flat and access all areas of the spoke.

   Pro tip: If you can't remove them, turn the wheel so the spoke you're working on is at the 9 o'clock position.

2. 2

   Clean Thoroughly

   Brake dust is extremely sticky. Use a dedicated wheel cleaner first, then rinse and dry, then finish with IPA on a cotton bud in all crevices.

   Pro tip: Brake dust contamination is the number one reason wheel decals fail prematurely.

3. 3

   Apply Decal to Spoke

   Peel the backing and position the decal centrally on the spoke. Use the squeegee to press firmly from centre outward.

   Pro tip: Wheel decals are typically smaller and more manageable than body graphics — work slowly and precisely.

4. 4

   Wrap Into Edges

   Use a trim tool wrapped in cloth to press the decal firmly into the inner edge of each spoke.

   Pro tip: A wooden cocktail stick wrapped in cloth is perfect for getting into tight spoke edges.

5. 5

   Heat to Conform

   Apply gentle heat over the full decal to fully activate the adhesive. Pay special attention to any curved spoke sections.

   Pro tip: Don't overheat — 30 seconds with a heat gun at 20cm distance is sufficient.